Make PCB

Practical Ways to Make PCB 

For those which often makes the PCB, this article may be useful for you. This time I will try to give an explanation about how to make PCBs with ease and get satisfactory results.To create a PCB that is not too complicated, maybe we can use a permanent marker. But what if the PCB that we will create a series that is so complicated, for example to make the PCB for the circuit microcontroller, of course if you use markers result will not be satisfactory, even the progress too hard. 

Therefore this time I will give explanations about the making of a practical PCB: 

Prepare drawing. Figure PCB we use do not use markers, we create an image of the PCB by using computer software. I personally, usually using Diptrace, Proteus, or Protel. 

Print the picture. If the picture is complete PCB we make, then terebut images printed on glossy paper. Then the printers that are used should also use a laser printer. If the trouble to find a printer Laser, we can print on regular printer, and then we print a copy of course results to the glossy paper. Do any of choosing a copy, try to use the photocopy machine that has excellent quality. 

Glossy paper problem, we can also use paper alternative calendar. Paper glossy calendar of course, on the contrary it is still blank. Now that space that we can use to print the PCB image.Glossy paper is used, the better thinner. Therefore, I usually exfoliate  glossy paper lining into 2 parts, so glossy paper containing the images had become very thin PCBs. 

Prepare the PCB. PCB board that we want to use must be clean.Wash the PCB board with soap, then dried, do not there is oil on the PCB board that we want to create.
Iron. Well ... here's the most important, why did I say the most important? Because this process is a reflection of hasli end PCB.Jka setrka already hot, attach pictures kta PCBs that have been printed on glossy paper on top of PCB board. After making sure his position is right, fold and tape the paper to avoid shifting. After that we flat iron, do not get passed one jalurpun. If pressed too long, the line will fade so that the path is broken. But if it is not long enough then path also can not stick. Iron with average 3-5 minutes. 

Once ironed, soak the PCB board into the water. Dipping time depends on the thickness of thin paper. Advice from my use of paper as thin as possible, because more and more good muydah results. After soaking, peel bit by bit of paper attached to the PCB board. Clean iia2 paper attached to the track with a brush. Clean thoroughly.
Thorough track. After the paper was clean benar2, check the track.If there is a path-breaking, fix it with markers. Bold lines also vulnerable. 

After making sure the track already right, stay straight dilarut with fericlorid. In the dissolution, keep the solution clean from  impurities such as gravel or something else, because dirt can damage the path completion ...
Once completed dilarut, clean with gasoline or thinner. Then be lathered up to clean ...

Well done, the process is easy with satisfactory results. What, still want to make manual PCB use markers? I Suggest you, just leave it ... ..
Good work ...